Advertisement
Removing the Front panel assembly
Prior to performing the following procedure, remove
the top cover and the HDD board assembly.
1.
Disconnect the card wire from connector CN602 on
the inside of the system control board on the left side
of the body.
2.
Remove the screw E on each side of the body.
3.
Remove the two screws F
body.
4.
Release the joint b on the bottom and the joint c
on each side of the body using a screwdriver. Move
the front panel assembly forward.
5.
Release the wire extending from the headphone
board under the front panel assembly from the two
clamps. Set the front panel assembly apart from the
body as far as possible.
6.
Disconnect the wire from connector CN501 on the
system control board and CN301 on the main
amplifier board. Remove the front panel assembly.
Joint b
F
Front panel assembly
Clamp
Front panel assembly
(See Fig.5~9)
on the bottom of the
Front panel assembly
F
Fig.7
CN301
Main amp board
Fig.8
Front panel assembly
System control board
CN602
Joint c
E
Main amp board
Fig.5
System control board
CN602
CN501
Fig.6
CN501
System control board
Fig.9
NX-HD10
CN301
Front panel assembly
Joint c
E
Front panel assembly
Clamp
Headphone board
1-7
Advertisement
