Table of Contents
Advertisement
4.
If you are installing the bagger for the first time
or moving it to a mower of a different size, install
or move the bagger clamp as follows:
A.
Select the appropriate hole in the back plate
for your mower size
B.
Install the bagger clamp in the hole using a
bolt (3/8 x 5/8 inch) and locknut (3/8 inch),
as illustrated in
fit over the mower frame securing the back
plate.
Note:
Do not remove or install the clamp to
remove or install the back plate when using
it on a mower of the same size. Lift the back
plate off of the mower.
Figure 7
1. Back plate
2. Slot for 36 inch SFS mower
decks and all TurboForce
mower decks
3. Hole for 52 inch SFS
mower decks
4. Hole for 44 inch SFS
mower decks
5.
Insert the lower pins of the bagger frame into the
holes in the back plate
(Figure
7).
Figure
7. The clamp should
5. Bagger clamp
6. Locknut (3/8 inch)
7. Bolt (3/8 x 1 inch)
(Figure
8).
6.
Lift the latches and slide the frame side pins into
them
(Figure
7.
Lower the latches to secure the bagger.
1. Back plate holes
2. Frame pin
g002157
8
8).
Figure 8
3. Latch
4. Lower pin
g002161
Advertisement
Table of Contents
