Motorola Bolt Smart Safe User Manual page 17

3. Identify all items in the box listed on the Quick Start Guide's first page or the Meet your
Product section of this manual. If any parts are missing or defective, please call Customer
Support at +1 (800) 485-8904 for replacement parts.
4. Insert four (4) new C Alkaline batteries into the battery compartment (located on the
inside le of the main compartment) by first opening and removing the battery cover.
According to Diagram A, ensuring correct polarity displayed on the battery cover, insert
the batteries, then replace and securely close the battery cover.
a. Do NOT use or place rechargeable batteries in the XL Smart Safe battery
compartment.
b. Do NOT mix old and new batteries.
c. Do NOT mix alkaline and standard (carbon-zinc) batteries.
5. Once the battery compartment cover has been closed, the "Battery" LED on the front of
the safe will be solid green (the internal lock may also be heard turning) if batteries were
installed correctly.
Set User Access Code
The process for setting the initial access code and updating the access code is the same. Simply
repeat steps 1 through 4 if you need to update the access code in the future. The instructions can
be found in the Quick Start Guide.
Your XL Smart Safe features multi-user access.
1. If setting your safe up for the first time, use the default access code or backup key to open
your safe. If changing the access code, enter the current user access code on the keypad
to unlock the main compartment door.
2. With the main door open, press and hold the "ENT" key until the safe beeps.
3. Press 1 on the keypad followed by ENT to select the primary (owner) user. If setting an
access code for additional users, select the relevant number. E.g., if setting the access
code for the 2nd user—press 2 on the keypad followed by ENT.
4. Enter any 4 to 8 digit key length combination on the keypad and then press the "ENT" key.
The safe will beep, and the "Status" LED will flash yellow three times and then turn solid.
5. Re-enter the same combination again and then press the "ENT" key to confirm the new
user access code.
If the combination is accepted, the safe will beep, and the "Status" LED will flash green three
times. Otherwise, the LED will flash red three times, and you must close the main door and then
repeat steps 1 through 3.
ITSmart Security, LLC
16