Operation Mode When Battery Is Low - Epson Mobilink TM-P80II Technical Reference Manual

Operation Mode When Battery is Low

There are two modes of operation when the battery is low: Mode 1 and Mode 2. The default setting is Mode 1.
• The operation mode when battery is low can be changed using TM-P80II Utility or in the soft-
ware setting mode. See
• The battery level is detected before printing begins, and the displayed level is subsequently
updated. The battery LED does not indicate real-time battery level.
• When the battery level reaches the "L" level, it is recommended to recharge the battery or
replace it with a charged battery.
• When the battery level reaches the "S" or "E" level, recharge the battery or replace it with a
charged battery.
• A buzzer can be activated when the battery level reaches the L or S level. The buzzer setting can
be changed using TM-P80II Utility or in the software setting mode. See
page 58
Mode 1
Allows you to print until the battery runs out.
Level Battery LED
H
M
L
S
E
∗ Printing is possible, but printing may stop halfway through. Print quality cannot be guaranteed.
Mode 2
Printing stops when the remaining battery level falls below approximately 10%.
Level Battery LED
H
M
L
S
E
"Software Settings" on page 58
for more details.
Error LED
(Off ) Approx. 100 to 60%
(Off ) Approx. 60 to 20%
(Off ) Approx. 20 to 10%
(Off ) Less than approx. 10%
(On) Approx. 0%
Error LED
(Off ) Approx. 100 to 60%
(Off ) Approx. 60 to 40%
(Off ) Approx. 40 to 20%
(Off ) Approx. 20 to 10%
(On) Less than approx. 10%
Chapter 1 Product Overview
for more details.
: ON
Battery Level Printing
Possible
Possible
Possible
Possible*
Not possible
: ON
Battery Level Printing
Possible
Possible
Possible
Possible
Not possible
"Software Settings" on
: Flashing : OFF
Communi-
cation
Possible
Possible
Possible
Possible
Not possible
: Flashing : OFF
Communi-
cation
Possible
Possible
Possible
Possible
Not possible
25