Printing Specifications
Printing method
Dot density
Paper feeding method
Printing width
48 column mode (Standard column mode)
42 column mode
Characters per
48 column mode
line
(Standard column
mode)
42 column mode
Line spacing
*2
Maximum print speed
dpi: dots per inch
*1: Default setting
*2: When a new battery is used, the battery is fully charged, the room temperature is 25°C, and the print density is 100%.
*1
Font A
Font B
Kanji Font A
Kanji Font B
Kanji Font C
Font A
Font B
Kanji Font A
Kanji Font B
Kanji Font C
• The print speeds are measured under the following conditions: use of a new fully charged
battery, room temperature, and 100% print density. In addition, the speed changes
automatically depending on the voltage applied to the printer and head temperature.
• If the data transmission speed is slower than the maximum print speed, the print speed may
fluctuate and the print result may become shaded and/or dot displacement in paper feeding
may occur. Furthermore, if the data transmission speed is much slower than the maximum print
speed (for example, when using Bluetooth LE), intermittent printing will occur.
Thermal line printing
203 × 203 dpi
Friction feed
72.0 ± 0.2 mm {2.83 ± 0.01 in.}, 576 dots
68.3 ± 0.2 mm {2.69 ± 0.01 in.}, 546 dots
48
64
*1
Japanese: 24
Simplified Chinese: 24
Traditional Chinese: 24
Korean: 24
Japanese: 28
Korean: 36
Japanese: 36
42
60
Japanese: 21
Simplified Chinese: 21
Traditional Chinese: 21
Korean: 21
Japanese: 27
Korean: 34
Japanese: 34
3.75 mm {1/5 in.}
(Initial setting. Programmable by command)
100 mm/s {3.94 in./s} (Standard mode)
40 mm/s {1.57 in./s} (Fine mode)
Appendix
92