Electrolux EFP 4200 Manual page 41

General operating
instructions
Overload cut-out (EFP4400)
The appliance is equipped with an
overload cut-out, which switches
the appliance off if it starts to over-
heat, protecting the unit from
damage. When this happens, the
overload cut-out reset button
(fig. 1/N) jumps out.
If this happens, proceed as fol-
1
lows. Failure to follow this proce-
dure can result in damage to the
appliance, which is not covered by
the guarantee.
0 Allow the appliance to cool down
for at least 15 seconds.
0 Turn the speed selector (fig. 1/I) left
to "0" position (fig. 16/➀).
0 Remove the mix container or all-
purpose bowl (fig. 16/➁ and ➂), as
described at the relevant point in
these operating instructions.
0 Remove the mains plug from the
socket (fig. 17/➀).
0 Lay the appliance on its back to
gain access to the bottom
(fig. 17/➁).
0 Press the overload cut-out reset
button (fig. 1/N) on the bottom of
the appliance. If the appliance has
cooled down sufficiently, the but-
ton will engage (fig. 17/➂). If it
jumps back out, allow the appli-
ance to cool down a little longer,
then repeat the process.
0 Once the reset button has enga-
ged, put the appliance back to its
normal working position (fig. 18/➀).
0 Plug the power lead back into the
mains socket (fig. 18/➁).
0 Replace the mix container or all-
purpose bowl (fig. 18/➂ and ➃), as
described at the relevant point in
these operating instructions.
www.preciz.hu
0 The appliance is now ready for use
again. Turn the speed selector to
the right to the required position
(fig. 18/➄) and continue with the
function that was interrupted.
Mixer
(depending on model)
Preparing mixer
In order to fit the mix container, the
safety cover for the mixer drive
(figs. 1/T and 4) must be removed.
0 Turn the safety cover clockwise
and remove.
– The red warning lamp (fig. 4/a)
flashes.
0 Place the mix container (figs. 1/B
and 2) on the mixer drive (mark
on mark
clockwise to the stop. The mix
container is heard to engage (mark
on mark
– The red warning lamp (fig. 4/a)
extinguishes.
0 Only EFP4200: Place mixer cover
(figs. 1/C and 3) on mix container
and turn until the nose of the cover
is directly above the handle. The
cover can be heard to engage.
3 The mixer can only be switched on
when the container and cover are
fitted correctly.
0 Only EFP4400: Place mixer cover
on mix container.
The mixer can only be switched on
3
when the container is fitted cor-
rectly.
0 Fit closing cover (fig. 1/D) and lock.
Operating mixer
0 Open cover (fig. 1/C) and fill all
ingredients required in the con-
tainer.
Caution: Do not exceed maxi-
mum filling volume of 1.5 litres!
) and turn counter-
).
g
43