Page 1
WITH MOSQUITO CATCHER OPERATION MANUAL “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. * The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm , which is measured around the center of a room applicable fl...
Page 18
Please read before operating your new Air Purifi er The air purifi er draws in room air through the air intake, circulates it through a Pre- Filter and a HEPA Filter inside the main unit, and then discharges it through the air outlet.
Page 19
Lights light off and the UV Light less bright, while mosquito catcher function is still on. Thank you for purchasing the SHARP Air Purifi er. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”...
• If the power cord is damaged, it must interferes with radio or TV reception be replaced by the manufacturer, its service agent, a Sharp authorized If the air purifi er interferes with radio or Service Center or similarly qualifi ed television reception, try one or more of the persons in order to avoid a hazard.
Page 21
CAUTIONS CONCERNING INSTALLATION GUIDELINES OPERATION • Avoid locations where the sensors are exposed to direct wind. • Do not block the air intake or air outlet. Doing so can cause the main unit to • Always operate the main unit in an malfunction.
PART NAMES FRONT Air Outlet Main Unit MODE Button, Light (green) (Press 3 sec.) Plasmacluster Ion ON/OFF Button OFF TIMER Button, Light (green) (Press 3 sec.) Filter RESET Button REPLACE FILTER Light (orange) Plasmacluster Ion Indicator Light (blue) CLEAN ION SHOWER Button, Light (green) (Press 3 sec.) LIGHT ON/OFF Button POWER ON/OFF Button MOSQUITO CATCHER Button...
Page 23
BACK Hold this Handle when lifting the main unit. (INSIDE) INCLUDED • Glue Sheet : 2 pieces UV Light Upper Hook HEPA Filter Bottom Hook Pre-Filter Power Cord Pre-Filter Tabs Plug (Shape of plug depends on country.) Catch Panel Air Inlet Handle Glue Sheet Magnet...
FILTER AND GLUE SHEET INSTALLATION To maintain the quality of the fi lter and Glue Sheet, it is installed in the main unit and packed in plas- tic bag. Be sure to remove the fi lter and Glue Sheet from the plastic bag before using the main unit. Remove the Catch Panel from Remove the fi...
Page 25
Be sure to remove the power plug from the wall outlet. Remove protective film slowly Remove the Glue Sheet from the from the corner of Glue Sheet. plastic bag. ・Dispose protective fi lm as ・ Keep the additional Glue Sheet burnable rubbish.
OPERATION START / STOP START STOP • Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in. CLEAN ION SHOWER Releases high-density Plasmacluster ions and discharges strong air fl ow for 60 minutes. NOTE •...
Page 27
MOSQUITO CATCHER Use this function when there is concern about mosquitoes. UV Light ON UV Light OFF NOTE • When UV Indicator Light is fl ashing, please replace the Glue Sheet with a new one. • Select MAX mode to catch mosquito more effectively. The higher the air volume is, the easier it is to capture a mosquito.
CARE AND MAINTENANCE To maintain optimum performance of this air purifi er, please clean the main unit including the fi lter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. Do not WASH HEPA FILTER When the smell is generated from the Air Outlet...
Page 29
Be sure to remove the power plug from the wall outlet. PRE-FILTER Gently remove dust from the Pre-Filter, using a vacuum cleaner attachment or similar tool. Pre-Filter CAUTION Do not apply excessive pressure, when scrubbing the Pre-Filter. NOTE How to clean hard to remove dirt Pre-Filter 1.
REPLACEMENT GUIDELINES HEPA FILTER Replacement timing When REPLACE FILTER Light turn on. HEPA Filter Model : FZ-F30HFE Replace the fi lter according to the instructions provided with the replacement fi lter. Glue Sheet After the exchange, insert the plug in socket and press the POWER ON/OFF Button, and OFF TIMER Button 3 seconds.
Page 31
Be sure to remove the power plug from the wall outlet. GLUE SHEET Replacement timing When UV Indicator Light is fl ashing. Model : FZ-STS2M Replace the Glue Sheet according to the operation manual included in the replacement Glue Sheet. Please discard the used Glue Sheet carefully.
Lights lights up more than 3 sec.) more than 3 sec.) for 8 seconds, the setting is ‘ON’. Any two of MODE Lights are • UV Light has failed. Please call the service center approved by fl ashing Sharp. EN-14...
SPECIFICATIONS Power supply 220V 50Hz Fan Speed Adjustment SLEEP Rated Power Fan Speed Operation Fan Speed 180m /hour 120m /hour /hour Standby Power 0.7W Recommended Room Size ~23m High density Plasmacluster ion recommended room size ~16m Cord Length 2.0m Dimensions 438mm(W)x253mm(D)x444mm(H) Weight 4.7kg...