Datakey [On, Off]; Dev; Device [Dce, Cts Key]; Dkey - GE DS-SD4-1 Reference Manual

Table of Contents

Advertisement

Key on Data Activity
Modem Deviation
Data Device Mode
Unkey Transmitter
Diagnostic Link
28

DATAKEY [ON, OFF]

The
command enables or disables the ability of the radio to key
DATAKEY
the transmitter as data is received at the
Asserting RTS keys the radio regardless of this command setting.
If
is set to
DATAKEY
received at the transceiver's
set to
, the radio needs to be keyed by asserting RTS.
OFF

DEV

Displays modem control deviation in Hertz (Hz). This is a read-only
command, and cannot be changed in the field.

DEVICE [DCE, CTS KEY]

The
command controls or displays the device behavior of the
DEVICE
radio. The command parameter is either
In
mode (the default setting), CTS will go high following RTS, sub-
DCE
ject to the CTS programmable delay time. If the
set to
, keying can be stimulated by the input of characters at the data
ON
port. Hardware flow control is implemented by signaling the CTS line if
data arrives faster than it can be buffered and transmitted.
In
mode, the SD is assumed to be controlling another radio. The
CTS KEY
SD will still key based on the RTS line, but the CTS line is used as a key-
line control for the other radio. CTS is asserted immediately following
the receipt of RF data, but data will not be sent out the
port until after the CTS programmable delay time has expired. (This
gives the other radio time to key.)

DKEY

This command deactivates the transmitter after it has been keyed with
the
command.
KEY

DLINK [ON/OFF/xxxx]

Use this command to configure the local diagnostic link protocol used
in network-wide diagnostics.
Entering
enables the diagnostic link. Entering
DLINK ON
ables the diagnostic link.
To change the diagnostic link, enter
lowing baud rates: 1200, 2400, 4800, 9600, 19200 (default), 38400,
57600, 115200.
SD Series Reference Manual (x710 Mode)
DATA INTERFACE
, the radio will key when a full data-character is
ON
DATA INTERFACE
DCE
DLINK
connector.
connector. If
DATAKEY
or
.
CTS KEY
command is
DATAKEY
DATA INTERFACE
DLINK OFF
followed by one of the fol-
MDS 05-4670A01, Rev. E
is
dis-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mds sd series

Table of Contents