Table of Contents
Advertisement
mounting the transceiver 9
network-wide diagnostics 44, 46
operation 21
troubleshooting 40–41
Product
description 3, 4
display model number code (MODEL command) 31
display radio serial number (SER command) 36
model number codes 6
Programming radio as root or node 46
Programming, transceiver 21–39
protocol
TFTP 50, 52
PTT
command 34
PWR
command 34
LED 19
R
Radio
Configuration Software 48
serial number, displaying (SER command) 36
Receiver
specifications 44
system specifications 43
Redundant operation, defined 58
Remote
Station, defined 58
Station, illustrated 9
Resetting
transceiver (INIT command) 30
Revision level
display software (SREV command) 37
RSSI
command 34
RTU
command 35
RTU (Remote Terminal Unit)
defined 58
RX command 35
RXTOT command 36, 39
S
SCADA (Supervisory Control And Data Acquisition),
defined 58
SCD command 36
SER command 36
Set
alarm output state (ASENSE command) 25
alarm triggers (AMASK command) 25
receive time-out timer value (RXTOT command) 36, 39
SHOW command 36
Signal
loss due to coaxial cable length at 960 MHz, table 12, 15
Simplex 7
single-frequency operation 8
special case of switched carrier operation 8
Sleep mode
shown by PWR LED status indicator 19
SNR command 36
Software
diagnostics and control used from PC 48
display revision level 37
upgrading 48
Specifications
MDS 05-4670A01, Rev. E
diagnostics interface 44
environment 44
power 44
receiver 44
receiver system 43
transmitter 43
transmitter system 43
SREV command 37
Standing Wave Ratio—See SWR. 58
STAT command 38
Supervisory Control And Data Acquisition—See SCADA. 58
surge suppression 18
SWR (Standing Wave Radio), defined 58
T
Tables
alarm code definitions 41
command summary 21
conversions, dBm-Watts-Volts 55
LED status indicators 19
length vs. loss in coaxial cables at 960 MHz 12, 15
Technical reference 43–55
TEMP command 38
Temperature, displaying internal (TEMP command) 38
Timer, set/display time-out value and status (TOT
TOT command 39
Transceiver
applications 6
diagnostics using PC software 48
mounting 18
mounting instructions 9
programming 21–39
upgrading software 48
Transmitter
specifications 43
system specifications 43
Troubleshooting 40–41
performing network-wide diagnostics 44, 46
STAT command (Status) 40
using PC software for 48
TX command 39
SD Series Reference Manual (x710 Mode)
command) 39
I-3
Advertisement
Table of Contents
