Table of Contents
Advertisement
Upgrade Procedure
(TFTP)
MDS 05-4670A01, Rev. E
REMOTE PC
W/FIRMWARE FILE
TFTP
SERVER
ETHERNET
PORT
IP ADDRESS: w.x.y.z
Figure 21. Firmware Upgrade Setup—Option 2
(TFTP Server and Firmware File Must Reside on Same Computer)
To load a new firmware file (
follow these steps:
1. Connect an Ethernet cable between the radio's
(refer to Figure 20 or Figure 21, as applicable). Verify that the
yellow LED on the radio's
that the network is functioning.
2. Launch the TFTP server on the PC. If using the GE MDS TFTP
Server, click the
Options
(B) using your browser to point to the folder where the
Outgoing path
reprogramming package (
displayed once the operation is completed. Leave the application
running until reprogramming on the radio is complete.
Figure 22. TFTP Server Screen
3. Launch a Telnet session and connect to the radio using its pro-
grammed IP address (the radio and PC must be on the same IP net-
work to connect via Telnet).
SD Series Reference Manual (x710 Mode)
Invisible place holder
HUB/LAN/WAN/MAN
TCP/IP
TO LAN
PORT
INITIATE UPLOAD
FROM HERE
) into the transceiver via TFTP,
filename.mpk
port lights and stays lit. This verifies
LAN
tab (A in Figure 22 below) and modify the
file) is located. The path (C) will be
.mpk
(GE MDS Server shown)
TRANSCEIVER
port and the PC
LAN
51
Advertisement
Table of Contents
