Advertisement
8. Remove and discard the 4 sets of bolts, washers, and
locknuts from the housing as shown in Figure 3.
Figure 3
1. Bolts
9. Remove the discharge chute or Recycler cover from the
mower housing.
Creating the Slots
1. Insert the template into the holes in the housing toward
the front as shown in the inset in Figure 4.
4
1
Figure 4
1. Template
2. Drill
3. Straight edge
2. Drill the holes (3 mm) in the front of the housing using
the "F" (front) side of the template and a straight edge
as shown in Figure 4.
3. Remove the right rear tire and block the machine to
support it.
1
m-5981
3
m-6682
2
4. Edge of the opening in
the housing
4. Insert the template into the hole in the housing toward
the rear as shown in the inset in Figure 5.
Figure 5
1. Template
2. Drill
3. Straight edge
5. Drill the holes (3 mm) in the rear of the housing using
the "R" (right) side of the template and a straight edge
as shown in Figure 5.
6. Use a file or a die grinder on both the front and rear sets
of holes to make 2 slots for the straps.
7. Insert the ends of the straps into the front and rear slots
(Fig. 6).
1
Figure 6
1. Insert the strap end into
the front slot.
8. Install the 4 sets of short bolts, washers, and locknuts
provided in the kit to replace those you previously
removed in step 8 of Removing the Recycler Cover or
Discharge Chute above.
2
3
1
4
5
m-6681
2
4. Edge of the opening in
the housing
5. Clamp
2
m-6362/m-6363
2. The strap end is in the
front slot.
Advertisement
