Installation - Mitsubishi Electric AE-SW Series Instruction Manual

Installation

< Drawout type >
Installation surface flatness
1 mm or less
Fig. 8-1
For AE4000-SW ~ AE6300-SW 3-pole and 4-pole (HN) products, insert four M12 bolts from the bottom and two from
the back and attach the cradle as shown in Fig. 8-3. For the 4-pole (FN)* products, insert six M12 bolts from the bot-
tom and two from the back and attach the cradle as shown in Fig. 8-4.
AE4000-SW ~ AE6300-SW 3-pole & 4-pole (HN)
Installation bracket
Cradle
(Panel side:non-magnetic steel)
4×M12
Fig. 8-3
Perform drawout operation (connect position to drawout position) as instructed. (Refer to P.14 and 15)
Lifting using a lifter or with
lifting hook(HP)
Lift
Fig. 8-5
< Fixed type >
lAppropriate tightening torque
Bolt size Tightening torque (N m)
M12 45±5
M12
M8 Earth terminal
(standard supply)
* Insertion direction of bolts is arbitrary.
Fig. 8-8
E-8
AE630-SW ~ AE3200-SW, AE2000-SWA, AE4000-SWA
Insert M12 bolts from above, and attach the cradle.
lAppropriate tightening torque
Bolt size Tightening torque (N m)
M12 45±5
M12
Weld nut
(included
2×M12
as standard)
Max.
25 mm
Bolt
*4-pole product (FN): 4-pole product of which neutral poles have the same current capacity
as the other poles.
CAUTION
When the main body is drawn out,
the center of gravity shifts to the
front. If the cradle is not secured,
take measures against overturning
and dropping.
Fig. 8-6
Precautions for mounting
lMounting direction
lEarth terminal
Unless there are any special circumstances, connect the earth terminal to the ground.
Bolt
Nut
M8
Earth terminal
Fig. 8-2
AE4000-SW ~ AE6300-SW 4-pole (FN)*
Installation bracket (Panel side:non-magnetic steel)
Fig. 8-4
On AE4000-SWA,AE4000-SW ~ AE6300-
SW, the center of gravity of the cradle
is located at the terminal position.
When the main body is removed from
the cradle, the cradle may turn over
backward. Take measures against
overturning.
Fig. 8-9
Max.
14 mm
Weld nut
(included
2×M12
as standard)
Max.
25 mm
6×M12
Bolt
CAUTION
Supporter
Fig. 8-7