Setting up LAN Communications
5-20
Maintenance: Disassembly Guidelines
4.
Insert the new communications board, sliding it onto the rails until it is seated in
place.
5.
Replace the panel surrounding the LAN and modem ports.
6.
Replace the battery and AC power cable.
After replacing the communications board, use the following procedure to set up the
system's LAN communications.
NOTE:
Acquire the IP address, gateway, and subnet mask from the network
administrator before beginning this process.
1.
Power on the MAC system.
2.
From the Main Menu, select System Setup.
3.
If prompted, enter the system password.
The default password is system.
4.
From the System Setup menu, select Basic System > Network Setup.
The Network Setup window opens.
MAC 5500 resting ECG analysis system
2020299-020
Revision E