Maintenance - Kenwood CG-931 Instruction Manual

Be sure to disconnect the power cable from the socket before conducting the following operation.
P E P L A C I N G T H E F U S E
In case the fuse has blown, locate the cause. If the fuse
itself is the cause, replace it a follows:
1. Pull the plug of the power cord from the power
outlet.
2. Remove the fuse holder in the rear panel using a
standard screwdriver.
3. Take out the blown fuse, and in its place, insert a
new fuse.
4. Set the label of your line voltage to the mark • , then
plug the fuse holder containing the new fuse into the
rear panel.
C H A N G I N G T H E S U P P L Y V O L T A G E
Remove the fuse holder in the rear panel using a
standard screwdriver. Then set the label of your line
voltage to the mark • and plug the fuse holder back
into place. When changing the supply setting from
100/120 V to 2 2 0 / 2 4 0 V, change the 0.7 A fuse for
a 0.3 A one.
18

7. MAINTENANCE

.Caution: Read this page carefully to keep your safety.
For Electric Shock Protection:
Fuse holaer