WARNING
THE FOLLOWING ADJUSTMENT INSTRUCTIONS
ARE FOR USE BY QUALIFIED PERONNEL ONLY. TO
AUOID PERONAL INJORY. DO NOT PERFORM ANY
SERVICING OTHER THAN THAT CONTAINED IN OP-
ERATING INSTRUCTIONS UNLESS YOU ARE QUALI-
FIED TO DO SO.
1) Removing the case
Using a Phillip's screwdriver, remove the 7 screws
located on the top and side panels.
8. A D J U S T M E N T
2) Adjusting the sub-carrier frequency
C17
C1 2
VR15
VR16 ••-Adjusts the
Connect a counter to the sub-carrier output on the
rear panel and adjust C17 using the insulated
adjustment rod. [For the CG-932, adjust C12. BE
SURE NOT TO TOUCH C 1 7 . ]
Front
Adjusts the subcarrier frequency in the CG-
931 . Be sure not to touch this trimmer in the
CG-932.
Adjusts the sub-carrier frequency in the C G -
932. This trimmer is not provided in the CG-
9 3 1 .
-Adjusts the RF frequency for CH A.
frequency for CH B.
19