Installation and configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking a rack system Unpack your system and identify each item. Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system.
Connecting the power cable(s) Figure 3. Connecting Power Cable(s) Connect the system’s power cable(s) to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. Securing the power cable(s) Figure 4. Securing power cable(s) Bend the system power cable(s), as shown in the illustration, and attach to the cable strap.
Install the bezel. Setting up the system For information about setting up your system, see the Dell See the XC720xd Solutions Guide available at support.dell.com. The Solutions Guide also provides information about Nutanix Account setup, license activation and management, deployment and recovery of the system, documentation access, and...
Dell software license agreement Before using your system, read the Dell and Nutanix Software License Agreements that came with your system. You must consider any media of Dell-installed software as BACKUP copies of the software installed on your system’s hard drive. If you do not accept the terms of the agreements, call the customer assistance telephone number.
Page 7
3.5-inch hard disk drive systems 10.3 kg (22.7 lbs) Environmental NOTE: For additional information about environmental measurements for specific system configurations, see dell.com/environmental_datasheets. Temperature Continuous operation: 10 °C to 35 °C at 10% to 80% Operating relative humidity (RH), with 26 °C max dew point.
Page 8
Environmental Operating 20% to 80% (noncondensing) at a maximum wet bulb temperature of 29 °C (84.2 °F) Storage 5% to 95% at a maximum wet bulb temperature of 38 °C (100.4 °F) Maximum Vibration Operating 0.26 G at 5 Hz to 350 Hz (all operation orientations) Storage 1.87 G...