Hitachi EUP-B712 Instruction Manual page 26

3.3.4 Removing the Magnetic Sensor (EZU-RV3S)
The procedure of releasing the Magnetic sensor from the probe is as
follows.
1) Press the area of the attachment shown with the arrow toward the
direction A, and then slide out the attachment toward the direction
B as shown in Fig. 19.
Press this
area
Fig. 19
2) Release the Magnetic sensor from the groove of the attachment as
shown in Fig. 20.
Fig. 20
Clean and sterilize the Magnetic sensor before the first use as it is
not sterilized in the factory.
A
How to release the attachment from the probe
How to release the Magnetic Sensor
from the groove of the probe
Slide the attachment
B
in this direction.
CAUTION
CAUTION
-20- Q1E-EP1412