Table of Contents
Advertisement
WARNING!
To reduce the risk of electric shock:
Plug the power cord into an AC outlet that is easily accessible at all times.
●
The power cord has a three-pin attachment plug. Plug the cord into a grounded (earthed) three-pin
●
outlet.
Disconnect all power sources. More than one power supply cable might be connected to the computer.
●
To reduce the risk of electrical shock, disconnect all power supply cables before servicing the system.
NOTE:
Your computer can use one or two power supply units in one of three configurations:
Single—One power supply is installed in the computer.
●
Redundant—Two power supplies are installed in the computer, but only one is in use at a time. If the
●
power supply currently in use fails, the computer automatically switches to the second power supply.
Augmented—Two power supplies are installed in the computer, and both are in use at the same time.
●
NOTE:
Do not use your computer as a desktop model. Instead, install it in a rack where its operational
sounds do not disturb a quiet environment.
NOTE:
Your computer is not intended for use with a monitor that is directly connected to the computer.
For first-time installation and setup:
1.
On select models, install the rails on the computer rack, insert them into the mounting holes on the
front of the rack (1). The spring clips secure the front to the rack (2). Then attach the rails to the
mounting holes at the rear (3), where a second set of spring clips secure the rear (4).
Setup procedures
9
Advertisement
Table of Contents
Troubleshooting
