Table of Contents
Advertisement
Lubrication
Greasing the Machine
Service Interval: Every 50 hours—Grease the
fittings.
Every 400 hours—Grease the internal parts.
Grease Type: No. 2 lithium or molybdenum grease
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings with a rag. Scrape any
paint off the front of the fitting(s).
4.
Connect a grease gun to the fitting. Pump
grease into the fittings until grease begins to
ooze out of the bearings.
5.
Wipe up any excess grease.
Note:
You will need to remove some of the
machine guards to reach all the grease fittings.
Replace the guards when finished.
6.
Every 400 operating hours, disassemble the
points shown in
Figure 5
grease.
1. Grease fittings—grease
every 50 hours
and apply anti-seize
Figure 5
2. Internal grease
points—grease every
400 hours
g015410
8
Advertisement
Table of Contents
