Husqvarna AUTOMOWER 450X Operator's Manual page 21

deactivate the alarm and to start the product again. The
GeoFence is only enabled when the product is switched
on.
® ®
3.9.8 Automower Connect (Bluetooth
only)
®
In Automower Connect you can enable or disable the
®
Automower Connect module. You can also see the
signal strength, connectivity status, initiate new pairing
or remove the product from the paired accounts.
3.9.9 Messages
In this menu the previous fault and information
messages can be found. For some of the messages,
there are tips and advice to help to rectify the fault.
If the product is disrupted in any way, for example it
is trapped or the battery is low, a message is saved
relating to the disruption and the time it happened.
If the same message is repeated several times, this
may indicate that an adjustment to the installation or the
Installation on page 11 .
product is required. Refer to
3.9.10 Download firmware over the air
(Firmware over the air FOTA)
The product has a function that automatically downloads
new firmware. When a new firmware is available, a
notification shows in the app where you can select
to install the new firmware. In the factory setting this
function is enabled.
1970 - 001 - 10.10.2022 Installation - 21