Husqvarna AUTOMOWER 450X Operator's Manual page 28

Message
Empty battery
Slipped
Wheel motor overloaded
right, left
Charging station blocked
Stuck in charging station
Upside down
Mower tilted
Lifted
Collision
28 - Troubleshooting
Cause
The product cannot find the charging sta-
tion.
The battery is at the end of its life cycle.
The antenna of the charging station is
defective.
The product has hit an obstacle and
stopped or the wheels cannot move on
the wet grass.
The work area includes a steep slope.
Grass or other objects is wound around
the drive wheel.
The connection between the charging
plates on the product and the contact
plates on the charging station is not
good. The product made a number of
tries to charge.
An object prevents the product to enter
the charging station.
The charging station tilts or is bent.
An object prevents the product to move
out from the charging station.
The baseplate has a wet or dirty surface
that prevents the product to move out
from the charging station.
The product tilts or is with the top down.
The product tilts more than the maximum
angle.
The lift sensor was enabled because the
product was lifted.
The body of the product cannot move
freely around its chassis.
The product cannot move forward or
rearward.
Action
The product has no accurate position
and cannot find the charging station.
There is an obstacle that prevents the
product to find the charging station.
Replace the battery. Refer to
page 25 .
If the LED indicator on the charging
station flashes red, the antenna of the
charging station is defective. Speak to
your approved servicing dealer.
Move the product and correct the cause
of problem. If it is because of wet grass,
wait until the lawn is dry before you use
the product.
Maximum guaranteed slope is 45%.
Steeper slopes should be isolated. Refer
To install the map objects in a slope
to
on page 13 .
Examine the drive wheel and remove
grass or other objects.
Put the product in the charging station
and make sure that the charging plates
and contact plates are connected.
Remove the object.
Put the baseplate on level ground.
Remove the object.
Clean the baseplate of the charging sta-
tion.
Put the product in the correct position.
Move the product to an area that has lev-
el ground.
Move the product. If the problem stays,
speak to your approved servicing dealer.
Remove dirt or object between the chas-
sis and the body of the product. Make
sure that the body of the product can
move freely around its chassis.
Remove the object that prevents the
product from operation.
1970 - 001 - 10.10.2022
Battery on