Husqvarna AUTOMOWER 450X Operator's Manual page 27

Message
No loop signal
Outside work area
1970 - 001 - 10.10.2022
Cause
The power supply or the low-voltage ca-
ble for the charging station is not connec-
ted.
The power supply or the low-voltage ca-
ble for the charging station is damaged.
ECO mode is enabled and the LED in-
dicator of the charging station flashes
green. The product was started manually
in the work area but the STOP button
was not pushed before the product was
moved from the charging station. The
charging station signal is disabled and
the product cannot enter the charging
ECO mode on page 19 .
station. Refer to
The product does not find the loop signal
from the charging station.
The charging station in not installed cor-
rectly.
Interference from metal objects such as
fences, reinforcement steel or buried ca-
bles near the charging station.
The work area slopes too much by the
virtual boundary.
The transport path or the path to the
maintenance point slopes too much.
The product can not find the correct
charging station signal because of inter-
ference with a loop signal from a different
product installation nearby.
Interference from metal objects such as
fences, reinforcement steel or buried ca-
bles near the charging station.
Action
If the LED indicator on the charging sta-
tion is out, it shows that there is no pow-
er. Examine the power outlet connection
and the residual-current device. Make
sure that the low-voltage cable is con-
nected to the charging station.
Replace the power supply or low-voltage
cable.
Put the product in the charging station.
Start the product. Refer to To start the
product on page 22 .
Put the product in the charging station
and make a new loop signal. Refer to
New loop signal on page 20 .
Install the charging station according to
To install the
the instruction. Refer to
charging station on page 14 .
Change the position of the charging sta-
tion.
Make sure that the virtual boundary is
To examine
installed correctly. Refer to
where to install the objects on the map
on page 13 .
Make sure that the transport path is in-
To install the
stalled correctly. Refer to
map objects in a slope on page 13 .
Put the product in the charging station
and make a new loop signal. Refer to
New loop signal on page 20 .
Change the position of the charging sta-
tion.
Troubleshooting - 27