Autocycling; Setting Cycle Time - GE Healthcare B30 User's Reference Manual

B30 Patient Monitor

Autocycling

Auto On/Off
The
Autocycling is synchronized to real time so that if the first measurement was at 12.02, the next
measurement is at 12.05 and again at 12.10 (5 min. interval.)
To start the autocycling, do one of the following:
•
Press the
press the
The bar at the bottom of the NIBP field shows the time remaining to the next
measurement.
To stop autocycling:
•
Press the
press the

Setting cycle time

The possible intervals for autocycling are 1, 2.5, 3, 5, 10, 15, 30 minutes or 1, 2 or 4 hours.
To set the cycle time:
•
Press the
•
Select the alternative with the ComWheel.
NIBP
16-6
key sets automatic NIBP measurement at selected intervals on and off.
Auto On/Off
module or side panel key, or
NIBP
key on the Command Board and select Start Cycling.
Auto On/Off
module or side panel key or
NIBP
key on the Command Board and select Stop Cycling.
NIBP
key on the Command Board and select Cycle Time.