Fujitsu ETERNUS AF250 S2 Site Planning Manual page 10

1. ETERNUS AF Installation
Installation Specifications
Item
Environmental conditions Temperature
Vibration limit
Noise emission (*8)
*1: For power distribution units, there are multiple types of exteriors. For details, refer to
Optional Power Supply Products" (page
*2: These values are for product ID ETFP4BU-L.
*3: These values are for product ID ETFP4DU-L.
*4: A 2U power distribution unit is composed of two 1U power distribution units.
*5: These values are for product ID ETFP16U-L / ETFP12U-L.
*6: These values are for product ID ETFP48U-L / ETFP32U-L.
*7: These values are for each enclosure when 24 drives are installed.
*8: These values are measured when a single controller enclosure and a single drive enclosure are configured
in an environment in which the temperature is 23 ± 2°C at 0 meters above sea level.
Temperature gradient
Humidity
Humidity gradient
Maximum wet bulb temperature
Altitude above sea level
Airborne dust
Gas concentration tolerance level
Oil vapor
Seawater (salt corrosion)
Operating
Not operating
Sound pressure level
Sound power level
18).
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Site Planning Guide
Copyright 2021 FUJITSU LIMITED
ETERNUS AF250
Operating 10 – 40°C
Not operating 0 – 50°C
Shipping -40 – 60°C
15°C/Hr or less
Operating 20 – 80%RH
Not operating 8 – 80%RH
Shipping 8 – 90%RH
30%/day or less
29°C
0 – 3,000m
0.15mg/m
Cl : 6.8ppb or less, H
2
SO : 37ppb or less, NH
2
NO
2
HCl: 6.6ppb or less, HF: 3.6ppb or less
0.2mg/m
If the ETERNUS AF is installed on the ocean or
premises within 0.5km from the coast, neces-
sary measures must be taken to prevent salt
corrosion.
400gal
1,000gal
47dB (A)
6.5B
10
3
or less
S: 7.1ppb or less,
2
: 423.5ppb or less,
3
: 52ppb or less, O : 5ppb or less,
3
3
or less
"Specifications for
P3AG-1812-06ENZ0