Maintenance
6.
Place the bottom of printer board in the grooves and snap the top edge on
each side back into position.
7.
Follow the printer assembly replacement procedures as described in
the Printer Assembly" on page
8.
Perform the applicable checkout procedures.
Refer to
Replacing the Printhead
Use the following procedures to remove and reassemble the printhead.
Removing the Printhead
Use the following steps to remove the printhead from the printer:
1.
Remove the printer board as described in
page
2.
Remove the stainless steel tube by pushing outward on the printhead holder
while pushing the tube as shown in the following illustration.
3.
Remove the screw (1) that fastens the pressure strip to the left printhead holder.
4.
Remove the left printhead holder in the same manner.
88
"Functional Checkout" on page
86.
MAC™ 1600
83.
99.
"Removing the Printer Board" on
"Replacing
2028451-183E