Table of Contents
Advertisement
Programming The Controller – 4
Having defined the programs, the next step is to enter specific
operating information for each satellite.
Satellite Setup
Select SATELLITES from the system Menu screen. The Satellites
screen will appear as shown in Figure 19.
Address Number
A unique satellite number must be entered for each satellite.
This number is important, as it is the actual receiving address
of the satellite.
Figure 19 - Satellites screen.
Without an accurate satellite address, the TouchNet cannot
communicate to the satellite. Each satellite address number
in the system should be different.
To set the satellite address, touch the box next to SATELLITE #,
then enter the desired number (0 through 255) using the pop-
up keypad.
Assigning a "0" address number will prevent stations on that
satellite from watering. This is the default value.
Name/Area
The Name/Area option allows you to rename the satellite as
you choose. The satellites are named by default as Satellite 1,
Satellite 2 etc.
To enter a name, touch the box next to NAME/AREA and enter
the desired name using the pop-up keypad. A maximum of 12
characters/spaces can be used.
22
RELEASED Version
©Toro 2006-2006
Advertisement
Table of Contents
