Table of Contents
Advertisement
Station Violates Flow Limit
If the station flow is greater than the flow capacity of the
System or the assigned Flow Zone, this alarm will be
generated. If this occurs, the run time of the station in violation
will be set to "0" which will prevent its operation.
To resolve the alarm, scroll through the station information on
the Stations screen to locate the station(s) which have be reset
to "0" run time. Reset the desired run time and the flow to a
value which is equal to or less than the System and Flow Zone
capacity.
Missing Connection To Paging Terminal
If the communication link between the TouchNet and the
paging terminal is interrupted or cannot be established, this
alarm will be generated.
The cause of the disruption may be mechanically related, such
as a loose cable connection, or by a radio transmission
received by the paging terminal while the TouchNet is
communicating.
To resolve the alarm, ensure the connection cable between the
TouchNet and paging terminal is properly installed. Also
ensure the paging terminal has power and is switched on.
Touch TEST CONNECTION to send a test signal to the paging
terminal. If communication is reestablished, the alarm will be
turned off and the system will resume normal operation. If the
alarm persists, reset the paging terminal by turning paging
terminal power off and on again.
If the alarm was generated by radio interference, the TouchNet
will automatically remove the alarm at the next scheduled
operating time.
Auxiliary Service Features
The TouchNet incorporates some auxiliary service features
which enable certain screen display characteristics to be
altered and discrete system information to be accessed.
Due to the technical nature of these features, they are not
readily accessible to the user and should be accessed with the
assistance of a qualified Toro service representative.
Contact an authorized Toro distributor for assistance.
42
Special Features – 6
RELEASED Version
©Toro 2006-2006
Advertisement
Table of Contents
