Table of Contents
Advertisement
Connecting the Long Hose
(4WD Models)
For a simpler method of connecting the long hose on
2WD models, refer to
Connecting the Long Hose (2WD
Models Only) (page
11).
1. Disconnect the hose from the hydraulic line on the left
side of the machine and from the tee fitting on the top
of the pump
(Figure
Note: Have a drain pan or a rag available to catch the
hydraulic fluid.
1
Figure 15
As viewed from under the machine
1. Hydraulic line
2. Install a tee fitting to the hydraulic line
3. Connect the 90 degree fitting end of the new short
hose to the hydraulic line tee fitting and the straight
fitting end to the tee fitting on the pump
and tighten both ends of the hose.
1
Figure 16
As viewed from under the machine
1. Hydraulic line
2. Tee fitting
4. Install the end of the long hydraulic hose to the inboard
port of the right wing cylinder and tighten the fitting.
15). Discard the hose.
G025597
2. New hose
(Figure
(Figure
G025295
3. Short hose
4. Long hose
5. Route the hose from the right wing cylinder along the
mid-length hose, under the hydraulic tank bracket and
to the new tee fitting
Note: Make sure that the hose is not twisted and does
not contact any hot, sharp, or moving parts.
g025597
16).
16)
g025295
10
(Figure
16) and tighten the fitting.
Advertisement
Table of Contents
