Table of Contents
Advertisement
Completing the Installation
1. Install the HOC pin into the HOC bracket at the
desired height of cut
Figure 26
1. HOC pin
2. Check the hydraulic-oil level and replenish the oil as
required; refer to the traction unit Operator's Manual.
3. Level the cutting unit; refer to the Cutting Unit
Operators Manual.
4. Lubricate the cutting unit and PTO driveshaft grease
fittings; refer to the cutting unit Operator's Manual.
(Figure
26).
2. HOC bracket
g025302
14
Advertisement
Table of Contents
