2-2. Control Panel
2-2-1. Replacement of Rotary Encoder
2-2. Control Panel
2-2-1. Replacement of Rotary Encoder
1. Main Panel
(1) Remove the three knobs near the rotary encoder to replace.
(2) Open the panel. (Refer to the section 1-2-1.)
(3) Turn off the power switch in the control panel. (Refer to the section 1-2-2.)
(4) Remove the LE-145 board. (Refer to "15. LE-145 Board" in the section 1-2-5.)
(5) Remove the nut of the rotary encoder to replace.
B2.6 x 4
Nut
Knobs
VR bracket
B2.6 x 4
LE-145 board
Rotary encoder
(6) Install a new rotary encoder in the reverse order of the procedures (1) through (5).
2-4
DVS-7000AE MMP1