Multi-Charger Components; Connecting An Ac Adapter To Power - HP Engage Go 10 User Manual

Multi-charger components

You can charge up to four mobility head units in the multi-charger. To identify charger features, use this
illustration and table.
NOTE: You can only use the multi-charger with mobile system with grip models and convertible system
with grip models.
Table 2-5 Identifying the multi-charger features
Features
1 Locking dial
2 RJ-45 (network) jack
3 Power switch

Connecting an AC adapter to power

To connect an AC adapter to the I/O connectivity base, use this procedure and illustration.
To connect an AC adapter to the I/O connectivity base, connect one end of the power cord to the AC
▲
adapter (1) and the other end to a grounded AC outlet (2), and then connect the AC adapter to the power
connector on the I/O connectivity base (3).
To connect an AC adapter to the mobility system when it is not connected to an I/O connectivity base,
▲
connect the AC adapter to a grounded AC outlet (1), and then connect the power adapter's USB Type-C
connector to the USB Type-C power port on the underside of the stand or stability base (2).
NOTE:
light does not turn on, even if the adapter is plugged into a wall socket.
The power light illuminates when a valid AC adapter is used. If an invalid AC adapter is used, the
4 Power light
5 Power connector
6 Security cable slot
Multi-charger components 9