Table of Contents
Advertisement
3
Hardware setup
Use these sections to set up and configure your mobile system.
Tools needed
You need a Phillips screwdriver and a Torx T15 screwdriver for procedures described in this guide.
Warnings and cautions
Before performing upgrades, be sure to carefully read all of the applicable instructions, cautions, and
warnings in this guide.
WARNING!
To reduce the risk of personal injury from electric shock, hot surfaces, or fire:
Disconnect the power cord from the AC outlet before removing the enclosure. Energized parts are inside.
Allow the internal system components to cool before you touch them.
Replace and secure the enclosure before restoring power to the equipment.
Do not connect telecommunications or telephone connectors to the network interface controller (NIC)
receptacles.
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord in a grounded (earthed) AC outlet that is easily accessible at all times.
For your safety, do not place anything on power cords or cables. Arrange them so that no one can
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging from the AC outlet,
grasp the cord by the plug.
To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper workstation setup
and provides guidelines for posture and work habits that increase your comfort and decrease your risk of
injury. It also provides electrical and mechanical safety information. This guide is located on the web at
http://www.hp.com/ergo.
IMPORTANT:
equipment. Before beginning these procedures, be sure that you are discharged of static electricity by briefly
touching a grounded metal object.
When the computer is plugged into an AC power source, voltage is always applied to the system board. You
must disconnect the power cord from the power source and wait 30 seconds before opening the computer to
prevent damage to internal components.
Locking and releasing the mobility head unit
The mobility head unit automatically locks to the dock when attached. To release the mobility head unit, press
the lock release button on the front of the dock's column.
Static electricity can damage the electrical components of the computer or optional
Hardware setup
13
Advertisement
Table of Contents
