Advertisement
13
13A
13A
13B
13C
13 POP-UP ROD LINKAGE & ADJUSTMENT
Place one end of Spring Clip (13C) on end of Ball Rod (13B). Insert Ball Rod
(13B) across and through hole in Strap (13D). Secure other end of Spring Clip
(13C). Insert bottom of Lift Rod (13A) into hole at top of Pop-Up Strap (13D).
Tighten with Thumb Screw (13E). Adjust Lift Rod (13A) function by adjusting
location of Thumb Screw (13E) along the Strap (13D) or by adjusting the hole in
which Ball Rod (13B) goes through Strap (13D). Be sure to leave enough space
between Lift Rod Knob (13F) and Spout Hub (13G) when Lift Rod is down.
13F
13G
13E
13C
13D
13E
13A
13A
13D
13B
ENGLISH
14
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below
the sink.
15
HOT
CLOSED
15 VALVE FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-
clockwise, open-counterclockwise.
MAINTENANCE & CARE
16
16A
16A
16 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (16A). Turn Valves
(16B) on and allow both hot and cold water to run for at least one minute each.
While water is running, check for leaks. To clean the aerator, disassemble Aerator
Housing (16A) by separating the Aerator Shell (16C), Basket (16D), and Washer
(16E). Once parts have been cleaned, reassemble by reversing steps.
4
FAUCET FUNCTIONS
OPEN
OPEN
16B
16E
16D
16C
COLD
CLOSED
Advertisement
