Motorola DCT2000 Installation Manual page 39

A d d i n g t h e I R B l a s t e r O p t i o n
I n s t a l l i n g t h e I R B l a s t e r
To install the IR Blaster:
Fit the transmitter into the mounting bracket (refer to Figure 4-1).
Plug the mini-pin connector into the
(refer to Figure 4-2).
DCT 2000
VCR
Remove the adhesive tape cover from the mounting bracket.
Position the IR receiver off center of the VCR receiver and then press firmly attaching the
mounting bracket on the VCR. Be careful to route the wire so that it does not prevent
loading videotapes.
C h e c k i n g t h e I n s t a l l a t i o n
The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCT 2000. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
jack on the rear panel of the DCT 2000 rear panel
IR