Motorola dct6412 User Manual page 26

Connecting HDTV – Video Only
Component Video (YPbPr)
Connect an RF coaxial cable to the cable wall outlet and the
1
connector on the DCT*.
CABLE IN
Connect the component video cables to the Y, Pb, and Pr
2
connectors on your HDTV and DCT*.
This connection supports only the high-definition video connection
between the DCT* and the HDTV. To connect the audio connections for
your HDTV, proceed to the following page. To connect your audio
connections for an A/V receiver, go to "Connecting Your DCT* to an A/V
Receiver – Audio Only."
IEEE 1394
If your HDTV has an IEEE 1394 connector, you can use the IEEE 1394
for both your video and audio connection:
Connect an IEEE 1394 cable to the
HDTV and DCT*.
On-screen graphics will not be displayed when you are using the
IEEE 1394 connection on the rear panel of the DCT*.
DVI
If your TV has a DVI input, use the DVI connection for your video:
Connect a DVI cable to the
the -
DVI HDTV
This connection supports only the high-definition video connection
between the DCT* and the HDTV. To connect the audio connections for
your HDTV, proceed to the following page. To connect your audio
connections for an A/V receiver, go to "Connecting Your DCT* to an A/V
Receiver – Audio Only."
For information on configuring your DCT* settings, see "Optimizing Your
DCT* for High Definition TV."
DVI
connector on your TV.
DCT6400 Series User Guide
1394
IEEE
- connector on the DCT* and
D OUT
19
connector on your