Test Run; Bacnet Communication Settings - Toshiba BMS-IFBN1280U-E Installation Manual

BN interface
5

Test run

To perform test run of the BN interface, BACnet communication settings and the equipment data of the connected indoor units
are required.
Items to be set during trial run
Equipment
Outdoor unit
Indoor unit
BN interface

5-1. BACnet communication settings

Set the IP address of the BN interface and the device object instance number of the BACnet communications. These setting
can set from Setting File Creation Software 2. For details, contact your dealer.
11-EN
Uh Line address
Uh Line address
IP address
BACnet communication device
identification number
When using together with a
central control device not
compatible with Uh Line
When replacing with a BN
interface that does not support
Uh Line
Indoor unit information
(DN code setting values)
Item
Line address
Line address
Unit address
Central control address
Group address
IP address
Network mask
BACnet device object instance
number
Setting of old BN interface
Setting for combined use with
old controller
Setting of old BN interface
Line address
Unit address
Central control address
Group address
Operation mode setting range
Temperature setting range
Fan speed setting range
Flap type
Ventilation amount setting
range
Ventilation mode setting range
Availability of ventilation
operation
Availability of save function
– 11 –
Installation Manual
Setting method
Use the DIP switch on the outdoor
unit circuit board.
Use the address setting function of
wired remote controller.
(Except for simple wired remote
controller)
Use Setting File Creation Software 2.
(See Section 5-1.)
When setup work (see Section 5-2)
is performed, the BN interface reads
out the set values from the indoor
unit and records them on the SD card
of the BN interface.
Perform setup work after changing
the device information of the indoor
unit.