How To Use Starboard In Projection Mode; Usb/Serial Connection - Hitachi HTCB-77G User Manual

Cambridge Board

2.2 How to Use StarBoard in Projection Mode

2.2.1 USB/Serial Connection

(1) Connect devices following the page 1-8 (USB) or 1-9 (Serial).
(2) Power up the projector.
(3) Power up the Cambridge Board.
(4) Power up PC to start up Windows.
(5) Adjust the position of the projector so that the Windows screen projected by the
projector is within the pen input active area.
(6) Install and launch the StarBoard Software.
Starting StarBoard Software manually
Select [Start] → [Programs] → [StarBoard Software] → [
double-click the StarBoard Software icon on the desktop. (A StarBoard Software icon
will not be created on the desktop unless [Desktop] is checked in the shortcut creation
step during the software installation process.)
If the board is not detected by the StarBoard Software, check whether Cambridge
Board power is on, and whether the Cambridge Board and the PC are properly
connected to each other.
You can perform the board detection using the StarBoard Software. Refer to the
StarBoard Software User's Guide for details.
(6) Refer to the StarBoard Software User's Guide for information on using
the Cambridge Board.
If the cursor location of the PC is different from the pen tip, launch the calibration
programme. Please refer to the StarBoard Software User Guide for details.
2-3
Usages
StarBoard Software], or
English