Page 1
* The figure above shows a combination of this product and the separately sold ceiling mount bracket (for low ceilings) ET-PKL100S. Thank you for purchasing this Panasonic Product. To customers The “Installation Instructions” is intended for use by installation personnel. Be sure to employ certified personnel to perform the installation.
Electric shocks may result from contact with any metal objects inside the ceiling. r Panasonic Connect Co., Ltd. takes no responsibility for any accident or damage caused by the installation of the ceiling mount bracket using methods that are not described or methods that do not use the parts specified in these Installation Instructions.
Product description This is a projector mount bracket for installing projectors. ■ Applicable ceiling mount brackets ET-PKL100S (for low ceilings) / ET-PKL100H (for high ceilings) ■ Structural components Parts name Form (number of parts) Applications This is used to install the projector Projector mount itself.
Standard installation dimensions The dimensional relationship between the screen and projection is shown below. Establish the dimensions after assessing the area possible for installation. The projection distance can be adjusted using the zoom lens. Check the projection screen while making fine ad- justments.
Page 6
Standard installation dimensions (continued) Standard installation dimensions (continued) Note z This illustration assumes that the projector will be installed so that the projected image fills the screen and properly aligned with it. z This drawing is not in exact scale. Height of the projection area L(LW/LT)* Projection distance...
Installation After checking the height, width and structure of the installation location while referring to the “Dimensional rela- tionship diagram” in the “Standard installation dimensions” (pages 5-6) and “Dimensional relationship” in the Ap- pendix, determine the appropriate positions for setting up the screen and installing the projector. Setting up the screen Set up the screen according to the specified method in a position which takes into account the projection distance and angle and the type of screen being used.
Installation (continued) Attaching the projector drop-prevention kit Install the wire rope to the projector (sold separately). As shown in the figure on the left, secure the one end Wire rope (round crimping terminal) of the supplied wire rope to the A on the projector by using the 1 supplied captive washer screw (M4 x 12).
Specifications Horizontal tilt Range of adjustment ± 10 ° correction angle Width: 276 mm (10-7/8") External dimensions Height: 54.5 mm (2-5/32") Depth: 205 mm (8-1/16") Weight Approx. 0.7 kg (1.54 lbs) *1 When using the ceiling mount bracket ET-PKL100S (for low ceilings) or the ceiling mount bracket ET-PKL100H (for high ceilings).