Low Liquid Level Control; Cleaning And Care - Silvercrest COOK 'N' MIX Operating Instructions Manual

Low liquid level control

The integrated low liquid level control prevents the
appliance from starting when there is no liquid in
the blender jug 5.

Cleaning and Care

Ideally, you should clean the appliance immediate-
ly after use. Dried food residue is more difficult to
remove.
DANGER –
RISK OF ELECTRICAL SHOCK!
► Ensure that no moisture can get into/onto the
built-in plug 4 and the safety socket 2 on
the blender jug 5!
► Ensure that no moisture can get into/onto
the contact plug 1 on the lid on the blender
jug 9!
Never immerse the lid 9 in water or other
liquids! Otherwise there is a risk of an
electric shock.
WARNING! RISK OF INJURY!
Take care when cleaning the lid 9 and the
►
attached blades 6! The blades 6 are
extremely sharp!
1) Add a little warm water and a drop of washing
up liquid to the blender jug 5.
2) Place the lid 9 on the blender jug 5. Ensure
that the contact plug 1 in the lid 9 fits cor-
rectly in the safety socket 2.
3) Insert the connector 3 into the built-in plug 4
on the appliance.
4) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
5) Press the MODE button q repeatedly until the
MIXER programme indicator
flash.
6) Press and hold the START/STOP button i and
allow the appliance to run for about 20 seconds.
■ 10 │ GB │ IE
7) Remove the power plug from the mains power
8) Remove any stubborn residue in the blender
9) Afterwards, empty the blender jug 5 and
10) Wipe the exterior surfaces of the blender jug 5
11) Wipe the lid 9, blades 6 and sensor 7 with
z starts to
socket.
jug 5 or the blades 6 using a washing up
brush or a washing up sponge.
rinse it out thoroughly with clear water.
with a moist cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance.
a damp cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance. Ensure that no moisture can get into
the contact plug 1 on the lid on the blender
jug 9!
SMK 1000 B3