2-3.
Battery Harness
Procedure
1.
Remove the three screws, and then remove the CN panel (BATT).
2.
Release the battery harness from the clamper, and then disconnect the battery harness from the connector (CN102)
on the RE-340 board.
P2 x 3
CN panel (BATT)
Note
• When attaching the CN panel (BATT), be careful not to pinch the harness.
• When connecting the harness, arrange it as shown in the figure.
AXS-R7
CN102
(RE-340 board)
Harness
Clamper
2-3