2.
Remove the slot assemblies.
(1) Remove the two screws, and then remove the duct support plate.
(2) Remove the four screws.
(3) Remove the two slot assemblies.
Hole [A]
Boss [A]
Slot assembly
Bosses [B]
Note
• When attaching the duct support plate, align the boss [A] with the hole [A]. First tighten the screw (a),
and then tighten the screw (b). (Refer to the illustration.)
• When attaching the slot assemblies, align the four bosses [B] with the four holes [B].
3.
Install the removed parts by reversing the steps of removal.
AXS-R7
(a)
PSW2 x 5
(b)
PSW2 x 5
Slot assembly
Bosses [B]
Duct support plate
PSW2 x 5
PSW2 x 5
Holes [B]
2-16