Table of Contents
Advertisement
4. Installing the intercom panel
Warning:
The product must not be connected to the power supply before the wiring has
been completed.
1
4
DES 9900 VDP
5
3
1
0
0
6
1
2
1
3 4
5 6
1 2
1
2
DES 9900 VDP
Avidsen
5
3
1
0
0
6
19 av. Marcel Dassault, 37200 Tours
FRANCE
20V
110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring).
8 – Insert the screws and refit the two caps concealing the retaining screws.
Note:
screw through the black covers on the back of the intercom panel without removing
them.
9 – Refit the front cover of the intercom and tighten the tamper-resistant retaining screw.
Philips - Comfort - V3
2
5
2
1
1
2
8
1m60
3
6
9
EN7
Advertisement
Table of Contents
