Panasonic ET-JPF100BU Operating Instructions Manual page 11

Mounting procedure (continued)
■ Power cord disconnection procedure
3) Close the connector secure lock.
Tab
1) Make sure that the projector is in the standby
state and then remove the power plug from the
power outlet.
2) Push down on the tab of the connector secure
lock to release it.
Tab
3) Remove the connector secure lock by sliding it
along the guides on the <AC IN> socket.
Guide
4) Pull out the connector of the power cord from
the <AC IN> socket.
z Push until the tab of the connector secure lock
clicks into place.
z To release it when the projector is standing on
the floor, release the tab while lifting up the
power supply unit.
ENGLISH - 11