Table of Contents
Advertisement
11. COMMISSIONING
This chapter describes the correct sequence to install the external power supply.
Make sure to read the complete technical description before commissioning.
The 4466 will only be powerless when both fuses F1 and F2 are removed or the batteries are disconnected.
11.1.
USING AUTOMATIC ADDRESSING
a) Mount the external power supply housing. See chapter 9. MOUNTING on page 20.
b) Remove the fuses in this order : F1, F2, F3, F4.
c) Connect the mains cables to the 230 V terminal block. See section 10.1. POWER SUPPLY WIRING on page 23.
d) Select high or low current charging mode. See section 4.4.3. CHARGING MODE on page 10.
e) Connect the COM loop cables to the Terminal block J2. See section 10.3. EXAMPLE OF COM LOOP WIRING on page 25.
f) Connect the external equipment to the Terminal block J3.
g) Connect the batteries to the Connector J1.
h) When 4466 and all other units are properly installed on the loop, connect the system to the mains.
i) Put back the fuses in this order : F3, F4, F1, F2.
j) Attach the lid. See section 9. MOUNTING f) on page 20.
k) Perform the auto addressing function according to 7.1. AUTO ADDRESSING on page 17.
11.2.
USING MANUAL ADDRESSING
a) Mount the external power supply housing. See chapter 9. MOUNTING on page 20.
b) Remove the fuses in this order : F1, F2, F3, F4.
c) Connect the mains cables to the 230 V terminal block. See section 10.1. POWER SUPPLY WIRING on page 23.
d) Select high or low current charging mode. See section 4.4.3. CHARGING MODE on page 10.
e) Connect the batteries to the Connector J1.
Put the fuse F2 (battery) back during addressing, and then remove it again.
f) Perform the manual address and mode setting according to section 7.2. MANUAL ADDRESSING on page 17.
g) Connect the COM loop to the Terminal block J2. See section 10.3. EXAMPLE OF COM LOOP WIRING on page 25.
h) Connect the external equipment to the Terminal block J3.
i) Put back the fuses in this order : F3, F4, F1, F2.
j) Attach the lid. See section 9. MOUNTING f) on page 20.
26
Advertisement
Table of Contents
