Toro ProLine H800 Installation Instructions page 2

Installing the Kit
Installing the Kit
1. Open the hopper door.
2. Line up the door screen with the existing door mesh.
3. Use the 4 holes on the door screen to mark the 4 drill locations on the door mesh.
4. Drill 7.0mm holes in the door mesh at the marked locations.
5. Install the door screen onto the door mesh with 4 bolts, 8 washers, and 4 nuts
1. Door screen
2. Washer
3. Nut
6. Pull the release lever on the bottom of the existing hopper screen downward
Figure 1
4. Bolt
5. Existing door mesh
2
(Figure 1).
(Figure 2).
g320409