ABB RELION REX640 Installation Manual page 60

Mounting
3.
60
a) Spacer sleeves are used to increase the unjacketed fiber diameter to fit the
size of crimp ring.
b) Feed fiber through spacer sleeve and crimp ring, large diameter first. Slide
the spacer along the fiber until it is 63 mm (2½ inch) from the end of the
fiber. Bottom out the crimp ring on the spacer sleeve using a clockwise
turning motion (i.e. screw the crimp ring onto the spacer if necessary).
Figure 52: Attaching the crimp ring to the spacer sleeve
c) Holding cable, crimp ring and spacer in left hand and crimp tool in right,
insert small end of crimp ring completely into the front die nest of the
crimp tool.
Figure 53: Using the crimp tool
d) Squeeze crimp tool handles together until it clicks, then releases.
Strip Fiber Buffer
1MRS759115 E
REX640
Installation Manual