Installing A Pendant Arm Mount - Bosch AUTODOME 7100i Installation Manual

AUTODOME 7100i│AUTODOME 7100i IR
9

Installing a pendant arm mount

Notice!
Risk of water ingress
If you:
i
- remove a camera from its mount but do not replace it promptly, or
- install the mount but do not install the camera immediately,
then you must remove the PCB from the mount to avoid moisture or water ingress and
potential corrosion.
Notice!
Risk of damage to the camera
When you install the camera, you must attach the camera to the mount and tighten all screws
i
before you apply power (PoE and/or 24 VAC +/- 10%/ 36 VDC +/- 10%) to the mount (pendant
arm mount or pipe mount).
When you want to disconnect a camera from the mount, you must disconnect all live power
(PoE and/or 24 VAC +/- 10%/ 36 VDC +/- 10%) from the mount before you remove the camera
from the mount.
Notice!
i
Risk of permanent damage to the camera
The interface board connects only one way to the camera. Make sure that when you install it
in the mount (arm or pipe mount), you install it the correct way.
Notice!
i
Risk of permanent damage to the camera
The interface board connects only one way to the camera. Make sure that when you install it
in the mount (arm or pipe mount), you install it the correct way.
Notice!
Risk of leakage
i
When you place back the top cap of the wall arm, make sure the safety tether is attached and
well placed inside the product. For the product to be fully IP66, the tether needs to be
completely placed inside.
To the NDA-PEND-WPLATE mounting plate:
1.
2.
Bosch Security Systems
Connect the NDA-PEND-WPLATE mounting plate to the back of the pendant arm, as in the
figure that follows.
Remove the two (2) pieces of protective plastic at the outer edges of the mount. Note:
Liquid tight electrically grounded conduit must be used so that the IP66 rating is
maintained, and the metal conduit is electrically connected to the NDA-PEND-WPLATE.
Installation Manual
Installing a pendant arm mount | en 23
2023-02 | V01 |