Table of Contents
Advertisement
24
en | Installing a pendant arm mount
3.
4.
5.
6.
For audio and/or alarm inputs/outputs (I/O):
1.
2023-02 | V01 |
Put the appropriate cables for power, video, alarms, and audio through one of the access
holes in the wall mounting plate. Note: Use of proper grommets is needed, to guarantee
IP66.
Use a Torx wrench to install a grounding screw on the grounding connection point on the
wall mount plate, then connect the ground wire, as in the figure that follows.
Tighten the screws to 10-12 Nm.
A
B
1
2
Make the appropriate connections for PoE, 24VAC +/- 10%/36VDC +/- 10%, alarms, audio.
Note: If you connect fiber to the camera, then connect only 24VAC +/- 10% or 36VDC +/-
10% power input to the camera. Do not connect PoE.
On the mount on the camera side, connect the drain wire of the Belden cable (or similar
cable) to chassis ground and grounded metal box.
1
2
3
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
3
Bosch Security Systems
Advertisement
Table of Contents
