Table of Contents
Advertisement
Commercial Series TriTech and TriTech AM
detectors
7.3
Walk test LED
Before you begin the walk test, review the walk test LED indicator statuses. Refer to Walk test
LED.
At the beginning of the test, with no motion in the protection area, the LED should be OFF. If
you observe LED activity without movement, check for disturbances affecting the microwave
or PIR technologies.
The walk test LED indicates the detector's operational status.
2 min
Bosch Security Systems B.V.
RLED
RLED
ON
ON
OFF
OFF
RLED
NC
LOW
OFF
HIGH
LOW
ON
HIGH
Tritech AM
RLED
ON
OFF
NC
T
T
TR TR
RLED
OFF
ON
OFF
ON
OFF
ON
OFF
ON
During the warm-up period (after providing power to the
device), the LED flashes continuously until the device is
ready for use.
During walk test, the LED indicates PIR and microwave
activity activity and also a motion alarm condition (dual
alarm).
Installation manual
Configuration | en
OFF
ON
OFF
ON
ON
ON
OFF
ON
2022.01 | 01 | F.01U.401.708
31
Advertisement
Table of Contents
