Epson BrightLink 450Wi Quick Manual page 14

1. To start calibration, do one of the following:
Windows: click the
right corner of your screen), then select
(Advanced)
Macintosh: click the
menu bar, then select
2. After you read the message about calibration, click
3. Wait until you see a flashing green circle in the upper left corner of your
projected image.
4. Touch the center of the circle with the tip of the pen.
The circle stops flashing and turns black. You see another circle on the right.
5. Touch the center of the next circle, then repeat. When you get to the end of
the row, the next circle appears at the left edge of a new row.
Note:
For the most accurate calibration, make sure you hold the
pen at an angle to the projection surface and touch the
center of the circle.
Make sure you are not blocking the signal between the
pen and the interactive receiver (next to the projection window) on the projector.
Don't press the button on the side of the pen while calibrating.
If you make a mistake or want to stop calibrating, press Esc on your computer
keyboard. Then restart the calibration process as described above.
14
Getting Started
pen icon in the system tray on your taskbar (lower
.
pen icon in the Dock, select
Calibrate (Normal)
Calibrate (Normal)
Calibrate
or
Calibrate (Advanced)
.
OK
or
Calibrate
from the
.